HVAC (air source heat pump with heat recovery)

HVAC air source heat pump with heat recovery energy saving,cooling,heating, also supply hot water for domestic use.

HVAC air source heat pump with heat recovery

Model: HRCF/RH series

Cooling Capacity  5.5kw-30kw

Heating Capacity  6.2kw-34kw

Heat recovery     1.4-7.6kw

Refrigerant:  R407C,R410A,R290 

Compared with traditional chillers, the air source heat pump with heat recovery can provide hot living water on the basis of heating/cooling, the desuperheaters make use of the hot refrigerant vapor leaving the compressor to heat the water through a relatively small liquid to refrigerant heat exchanger without increasing the power consumption of the compressor. The dusuperheater can transfer 25 to 30 percent of the energy that would otherwise be dissipated by the condenser. 

STRUCTURE

Panels and base frame are made from galvanized steel protected with polyester powder painting to ensure total resistance to atmospheric agents.

HERMETIC COMPRESSORS

Single phase rotary type (mod. 5 only) and 3-phase scroll compressor (mod.8.5-30), with thermal overload cut-out and crankcase heater mounted on rubber vibration isolators. 

AXIAL FANS

External rotor type axial fans, equipped with single phase direct drive motors, low noise 6 poles, protection level IP54, provided with a protective outlet grille.

EVAPORATOR

High efficiency tube in tube type, factory insulated with flexible close cell material.

CONDENSER

Coils are consisting of seamless copper tubes mechanically expanded into blue hydrophilic aluminum fins, protected with flexible plastic grill.

DESUPERHEATER

High efficiency stainless steel brazed plate heat exchanger, factory insulated with flexible close cell material.

REFRIGERANT CIRCUIT

Copper tube connection with charge valve, filter, sight glass, gas-liquid separator, thermostatic expansion valve, low pressure switch with automatic reset, high pressure switch with manual reset.

The heat pump unit is completed also with 4-way valve, liquid receiver and one way valve.

HYDRONIC CIRCUIT

Built with air vent valve, water drain connection, and female-threaded hydraulic connectors.

ELECTRIC PANEL

consists of:  

Compressor contactor;

Compressor protection breaker;

Fan motor protection breaker;

Control circuit protection breaker;

Phase sequence relay (only for 3-phase power supplied units);

Programmable microprocessor controller 

OPTIONAL

Additional electric heater embedded in the coils for defrosting in low temperature ambient. It must be factory installed.

HVAC (air source heat pump with heat recovery)